If you have the water capacity and you want to turn on more than one station at a time, you can use your ROAM or ROAM XL remote control.

Learn to wire your Soil-Clik moisture sensor with Hunter's Pro-C, X-Core, I-Core, and ACC irrigation controllers. Soil-Clik can also be installed on non

This video shows you how to quickly reset your Hunter ROAM remote when it may not be responding to commands or you would like to wipe out any existing

One of the most common reasons for a sprinkler to start leaking between the pop-up riser assembly and the body cap while it is in operation is because

Installing a nozzle on a rotor is relatively easy. The procedure is the same for the PGJ, SRM, PGP-ADJ, PGP Ultra and I-20 rotors. This video will teach

This video teaches you how to connect, configure, and program a solar sync weather sensor with your I-Core controller. Installation of both the wired

Irrigation professional Mike Madewell will walk you through programing the Hunter I-Core controller. In part one basic start-up programming, Mike will

In part two advanced programming and extended features, Mike will go through seasonal adjust, cycle and soak, delay between stations and configuration

In part three HFS Hunter Flow Sensor set-up, Mike will go through installing a HFS flow sensor and setting up stations to be monitored, change overflow

This video shows you how you can use your Hunter ROAM XL transmitter with an existing ICR receiver using an addressing procedure.

This video shows you how to get up and running with some quick start features for your Hunter ROAM remote. Learn about how to set up your address, start

Video 7 of 8 installation of the Hunter Dual decoder two-wire system with I-Core controller. Tee-Splicing the two-wire path.

Video 8 of 8 of installation of the Hunter Dual decoder two-wire system with I-Core controller. Programming with the ICD-HP handheld programmer.

Introduction to installation of the Hunter Dual decoder two-wire system with I-Core controller. This video series will go over DUAL, a two-wire decoder

Video 3 of 4 installation of the Hunter Dual decoder two-wire system with I-Core controller. In this section we will instal the Dual 48M decoder output

Video 2 of 8 installation of the Hunter Dual decoder two-wire system with I-Core controller. Grounding the Controller is a vital step in the two wire

Video 4 of 8 installation of the Hunter Dual decoder two-wire system with I-Core controller. This section will go over connecting 2-Wire paths.

Video 6 of 8 of installation of the Hunter Dual decoder two-wire system with I-Core controller. Connecting DUAL-S surge suppressors in line and at the

Adjusting the arc and radius of a rotor is an easy task. Most residential rotors are adjusted the same way. There are two adjustments that can be made

This video covers how to extend a Hunter SmartPort using SRR-SCWH (shielded cable wiring harness) to residential irrigation controllers for lawn

The most common reason for a sprinkler to stop rotating is the accumulation of debris in the filter. This video will teach you how to clean the filter

This video will show you how to install the SmartPort, prepare the remote for operation, change the address, increase the number of stations or switch

A brief overview of how the Hunter Solar Sync works to convert most AC powered irrigation controllers to smart control. Learn why the Solar Sync saves

With a rotor tool, its easy to adjust the left stop, but ever wonder how to adjust the right stop after install? Hunter Technical Support will show you