The battery in the Wireless Rain-Clik™ Transmitter is designed to operate for the life of the sensor by providing a sealed, maintenance-free design. The transmitter is available as a replacement part (WRCLIK-TR). Should you need to change the transmitter, the receiver will have to learn the new transmitter address. Learn more
IMPORTANT: The battery inside the transmitter is NOT replaceable. It is sealed with epoxy which allows it to be free of any future corrosion.
To perform a battery test on the transmitter, you must view the receiver status to check if there is communication between the transmitter and receiver. Use the guides below based on your receiver status to verify the battery life.
If the receiver sensor status light is red, follow the steps below:
- Reestablish the address between the transmitter and the receiver using instructions here. If the readdressing procedure worked, the battery in the transmitter is good.
If the transmitter and receiver will not address, press and hold the quick response spindle on top of the transmitter for 10 seconds (perform this three times). If the LED light on the bottom of the transmitter flashes, perform Step 1 again. As a reminder, testing should only be performed when the sensor is completely dry.
Remove cap and spindle assembly. Inspect for any debris. Replace if necessary and repeat Step 1. Learn more
IMPORTANT: The LED on the transmitter can be difficult to see or may not flash. This does not indicate a bad battery.
If the receiver Sensor Status light is green, the battery in the transmitter is good. Follow the steps below to verify communication with the transmitter and receiver:
- Verify there is communication with the transmitter and the receiver by pressing and holding the quick response spindle on top of the transmitter for 10 seconds (perform this three times). The Sensor Status on the receiver should change to (RED - Sensor is wet).
- Release the quick response spindle on the transmitter. The receiver Sensor Status should change back to (GREEN – Sensor is dry).
- If the receiver Sensor Status does not change, try readdressing the transmitter with the receiver. Learn more
If the Wireless Rain Sensor transmitter needs replacement and the unit has a wire antenna (about 4"-5" inches long), you will need to replace both the sensor and the receiver with the WR-CLIK. The frequency changed with the solid style antenna. If the transmitter has this solid antenna, the replacement is the WRCLIK-TR for Wireless Rain Clik Transmitter and WRFCLIK-TR for the Wireless Rain Freeze Clik Transmitter. Warranty information can be found here.
Use our interactive lookup feature to find a Hunter distributor near you. - Get Hunter
По-прежнему нужна помощь? Мы к вашим услугам!
Изложите свой вопрос, и мы постараемся найти для вас оптимальное решение.