Supervisors - Page 24

The ACC2 controller allows up to six Pump and/or Master Valve outputs to be assigned in the controller. This applies to the decoder and conventional models. In this article, the following topics are covered:

USA

A new controller installation will begin with at least one or two ATTENTION messages, because the controller has experienced a "power outage" in shipping, and might be discovering new modules. This is normal. Messages on the screen do not interfere with normal irrigation.

When power is first turned on (either with the power switch, or closing one of the slide locks), the Hunter logo screen appears, and the controller begins searching for any irrigation events it may have missed during a power outage.

USA

About this event

Advance your education and obtain CEUs by attending this basic training and introduction to two-wire irrigation. Lunch will be provided to all attendees. Space is limited so register now to secure your spot.

 

You can manually test proper operation of the rain sensor by using the One Touch Manual Start. During the Manual All stations cycle, press the test button on the “Clik-type” sensor (eg. Mini-Clik®) to interrupt watering.

Note: The rain sensor will only interrupt watering in Manual All Stations and automatic programming.  Manual single station will override the sensor circuit.

USA

The most common reason for a valve to remain on, or weep, is debris. New installations without proper flushing, recent mainline repair, or well water can cause debris to flow into the valve and get caught between the diaphragm and the seat. Check for debris using the following steps:

USA

Pages