Pro-C® SP ERR MessageSólo disponible en inglés

Click derecho en el formato de video abajo y selecione Guardar Como...MOV | WMVDescargar

Category:

Product Lines:

Length:

Published: 
Mayo 17, 2019

SP ERR or ERR Message CAUSE - Noise entering the controller through the “SmartPort” wiring or it is wired incorrectly. SOLUTION - A few steps are necessary to determine cause of “Err” message. 1. Check SmartPort® Wiring If the “Err” message is displayed without a device attached, check that SmartPort® wiring is correct. Make sure that the SmartPort wiring is not bundled with the field wiring. The white SmartPort® wire must be attached on the terminal next to the blue wire on the REM terminal, then red above ground. See illustration to the right. 2. Replace the SmartPort® The SmartPort® connector may be damaged. Replace the SmartPort®. 3. Check Device (Remote Receiver) If “Err” message occurs when device is plugged into the SmartPort® the device may have the wrong station count set or the device may be defective and should be replaced. Check the maximum station count setting on your hand-held remote. If you need a new SmartPort® or hand-held remote receiver, Hunter makes our products and replacement parts available through our network of authorized distributors. Please click on the link below to find an Authorized Hunter Distributor in your area.

Productos destacados

Mas videos de Hunter

Los vídeos Hunter son la mejor fuente de conocimiento sobre los productos Hunter. Encuentre toda la información sobre características y ventajas de los productos Hunter. Haz clic abajo para empezar.