Designers - Page 16

The Pro-C controller is supplied with a factory-installed base module for up to 4 stations on the PC-400 and up to 3 stations on the older PC-300. Additional modules may be added in increments of 3 stations (PCM-300) or a single 9-station (PCM-900) to expand the controller’s station capability to 15-16 stations. Additional modules are sold separately. After inserting station modules, pressing the reset button should be done to allow full recognition.  Below you will find information on the compatibility of different modules for both the PC-300 and PC-400 controllers.

USA

A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time.

USA

Prior to the installation of the wall mount controller, it is recommended to remove the front door and face frame following the procedure below:

Tools required include: Drill with ¼"  bit (masonry or wood), level, and included bag/wirenuts with anchors.

Removing the Front Door Frame:

USA

A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time.

USA

About this event

Programação