Homeowners - Page 60

The MP Rotator has a lower precipitation rate than typical spray heads, so your run times may need to be lengthened compared to traditional spray heads. Your run times with the MP Rotator maybe two to three times longer than a standard spray zone. This is because the MP Rotator puts water down at a slower rate resulting in a significant reduction in the runoff, thus saving large amounts of water.

MP Rotator vs. Spray Nozzle at 40psi

USA

The distance of coverage for the MP Rotator is dependent upon incoming pressure. If you are not achieving the distance you desire, your incoming pressure may be too low to achieve the desired distance of coverage.

USA

If you have the most popular PGP model, there is a "blank" nozzle on the gray low-angle nozzle rack.  Or you can simply remove the red nozzle and put some bubble gum in it, then re-install the nozzle.

There are a couple ways to do this, but it's going to depend on which model head you are trying to shut off.

USA

Simply twist the solenoid on the valve counter clockwise 1/4 turn to 1/2 a turn. To shut off the valve, twist the solenoid clockwise until it is snug on the valve.

USA
Yes, Hunter tubing is 17mm in diameter and therefore our fittings are compatible with all other manufacturer's 17mm tubing.

 

 

 

USA

The easiest way to make adjustments on your Hunter rotor is to use a Hunter adjustment wrench. This tool can be purchased from your local distributor.

USA

Pages