Installers - Page 12

The high velocities that are common during initial activation of an irrigation cycle could cause the Flow-Clik to sense a “high flow” situation (primarily due to air trapped within the system) and subsequently shut down the irrigation system at the beginning of every cycle. The Flow-Clik addresses the problem by providing a programmable Startup Delay to allow the system to stabilize prior to the Flow-Clik monitoring for high flow conditions.

USA
 
Wiring the Sensor to the Interface Box
 
The red and black leads from the Flow-Clik sensor are connected to the red and black leads on the Interface Box. A minimum wire size of 18-gauge wire can be used to connect the leads from the sensor to the Interface Box. Secure all wire connections with waterproof connectors.
 
WARNING! This unit is designed to be installed in conjunction with 24 VAC circuits only. Do not use with 110 or 220 VAC circuits.
 
USA

If you want to run separate stations (or zones) on different days, you would use 2 different programs.  Hunter controllers have multiple programs (A, b, and C) and the ability for each program to have multiple start times.  To set up each program, you would need START TIMESRUN TIMES, and WATER DAYS for each of them.

Here is an example of a program for a 4 station controller:

USA

Here is a list of the error codes and ways to troubleshoot them:

USA

If you want to run separate stations (or zones) on different days, you would use 2 different programs.  Hunter controllers have multiple programs (A, B, and C) and the ability for each program to have multiple start times.  To set up each program, you would need START TIMES, RUN TIMES, and WATER DAYS for each of them.

Here is an example of a program for a 4 station controller:

USA

The XC Hybrid operates on six AA alkaline batteries (see fig. 1), and the XC Hybrid Stainless uses six C batteries (see fig. 2). A battery carrier is supplied with your controller. Insert the batteries as indicated on the battery carrier. Connect that battery connector inside the access compartment to the battery carrier and insert the carrier into the lower left side of the controller as shown.

USA

We would prefer that you use a Hunter valve with a Hunter DC latching solenoid, but we realize that sometimes you may be retrofitting existing systems that have another manufacturer’s valves. We have done testing on the following solenoids and have found these to operate with the Hunter SVC, WVC, NODE and XC Hybrid battery powered controllers. (some of these DC latching solenoids required a reduced system pressure, below 150 PSI (10.34 bars/1034.25 kPa), to ensure proper operation):

USA

Pages