Irrigation and Lighting Contractors - Page 2

Here is a list of the error codes and ways to troubleshoot them:

Metric

The CLIK DELAY option is designed to set number of days for watering to remain off, after sensor has been activated and restored.

Metric

The X2 Controller is compatible with Hunter Remote Controls (not included). The SmartPort® wiring harness (included with all Hunter Remotes) allows for fast and easy use of the Hunter controls. The Hunter remotes make it possible for you to operate the system without having to walk back and forth to the controller.

To install the SmartPort connector

Metric

A Hunter CLIK sensor or closed circuit type weather sensors can be connected to the X2. The purpose of this sensor is to stop automatic watering when weather conditions dictate.

Metric

NOTE: Complete this section only if you have a pump start relay installed. A pump start relay is a device that uses a signal from the controller to actuate a separate electrical circuit to energize a pump to provide water to your system.

The controller should be mounted at least a 15 ft (4.5 m) away from both the pump start relay and pump to minimize any potential electrical interference.

Metric

NOTE: Complete this section only if you have a master valve installed in your irrigation system. A master valve is a “normally closed” valve installed at the supply point of the main line that opens only when the controller initiates a watering program.  Whenever one of the irrigation zone valves is told to open by the controller, the controller also signals the master valve to open. The purpose of the master valve is to shut off the water to the irrigation system when none of the zone valves are operating. 

Metric

Below is a chart indicating the maximum wire runs that can be used when installing Hunter AC solenoids and valves.

Metric

MANUAL OPERATION will allow you to turn on the following without changing any of the automatic settings.

Existing program (A, B or C) - This allows you to turn on a program that has set run times and stations automatically programmed.

Single station - This will allow you to turn on any single zone from 1 second to 12 hours.

All stations - This will allow you to turn all station on one after another for a chosen run time.

USA

A schedule (program) needs 3 things for the controller to run automatically.

  • START TIME for the program.
  • RUN TIME for at least one station in that program.
  • DAY TO WATER for the program.

The NODE-BT controller has three programs (A, B, or C) for irrigation available.  Hunter controllers have multiple programs and the ability for each program to have multiple start times.

As an example, if you want to run separate stations (or zones) on different days, you would set up 2 different programs.

USA

The DASHBOARD screen provides an overview of the programming within the app.  

USA

Pages