Supervisors - Page 22

For drip irrigation systems using BTT, we recommend using regulation and filtration systems on all residential and commercial applications. Filters shall install directly on BTT's 3/4" hose thread outlet and connect to drip tubing providing regulated PSI.

Find a Hunter Distributor closest to you using our interactive lookup.  Get Hunter

Use the chart below for ordering reference.

USA

Choose from the links below for troubleshooting your BTT controller.

USA

The Accu-Sync compares the pressure on the top side of the diaphragm (main water supply pressure) to the downstream pressure.  Pressure is adjusted by the unit forcing the diaphragm downward until the desired pressure is achieved.  The Accu-Sync automatically adjusts to main water supply pressure changes.  To properly set the dynamic pressure (running pressure) on the lateral line with Accu-Sync installed, we recommend doing so using our MP Guage on the last head of the line.  You can purchase a Hunter MP Gauge Assembly (shown below at farthest head) to accurately check the pressure. See i

USA

With the Pro-C controller in production for 17 years, we have continueously made upgrades to accommadate the innovative features.  Below you will find every panel we manufactured for the Pro-C model including the NEW wifi replacement front panel.

For information on replacing the front panel, click here.

Hunter makes our products and replacement parts available through our network of authorized distributors. 

USA

Selecting Specific Days of the Week to Water

USA

We would prefer that you use a Hunter valve with a Hunter DC latching solenoid, but we realize that sometimes you may be retrofitting existing systems that have another manufacturer’s valves. We have done testing on the following solenoids and have found these to operate with the Hunter SVC, WVC, NODE and XC Hybrid battery powered controllers. (some of these DC latching solenoids required a reduced system pressure, below 150 PSI (10.34 bars/1034.25 kPa), to ensure proper operation):

USA

The ACC2 controller allows up to six Pump and/or Master Valve outputs to be assigned in the controller. This applies to the decoder and conventional models. In this article, the following topics are covered:

USA

About this event

Advance your education and obtain CEUs by attending this basic training and introduction to two-wire irrigation. Lunch will be provided to all attendees. Space is limited so register now to secure your spot.

 

You can manually test proper operation of the rain sensor by using the One Touch Manual Start. During the Manual All stations cycle, press the test button on the “Clik-type” sensor (eg. Mini-Clik®) to interrupt watering.

Note: The rain sensor will only interrupt watering in Manual All Stations and automatic programming.  Manual single station will override the sensor circuit.

USA

Pages