Pro-C - Not Recognizing Correct Stations If your Pro-C controller is not recognizing all of your stations in the "Set Station Run Times" or "Run Times" dial position, you may need to reset the station modules. Note: The numbers represented in the "Program Start TImes" or "Start Times" dial position represent the cycles for that program NOT station numbers. Visit this link for more information on start times if necessary. Here are the steps to reset the modules: Step 1 Turn the dial to the RUN. Step 2 Open front panel on controller. Step 3 Slide the black bar in the center of the controller to the Power Off or Unlock position. Step 4 Slide the upper station modules out to the right, and then back to the left position. Step 5 Slide the black bar back to Power On or Locked Position. Step 6 Press the RESET button on the backside of the controller door. Turn the dial to SET STATION RUN TIMES / RUNT TIMES and press the right arrow to see if controller recognizes all station modules installed on controller. The older PRO-C controller may require a paperclip to access the recessed reset button. The controller should now recognize all installed station modules.
BİREYSEL VE TİCARİ SULAMA