Eco-Logic - Installation

Remove lower access cover. Place a screw into the wall and hang the controller from the keyhole on the back. Secure the controller using one or more screws below the terminal strip.

One wire from each solenoid should be connected to the C terminal (common wire). The other wire from each solenoid to its respective number on the terminal strip.

Connect the transformer wires to the 24 VAC terminal strip. Attach the two sensor wires (if needed) to the SEN terminals. Connect a 9-volt alkaline battery (not included) to the battery wire clip. Plug the transformer into a nearby power outlet.

Installation Instructions
 

Still need help? We're here.

Tell us what you need support with and we'll find the best solution for you.

Contact Support