Installers - Page 33

FLOW MANAGER runs simultaneous stations to reach a programmable flow rate target. It allows the controller to decide which stations to run, to keep the total flow as close to the pipe design capacity as possible, and shorten the overall watering time. Using this feature does NOT require a flow sensor, but it must have station flow values configured. If flow learning via a sensor is not available, approximate values may be entered manually.

USA

A BLOCK is an electronic group of stations that runs at the same time, for the same run time, within a program (Blocks replace “SSGs” in original ACC).

USA

The primary use for this setting is to allow stations to be named. Most other functions are described in more detail in the Flow Operations section.

USA

The ACC2 controller allows up to six Pump and/or Master Valve outputs to be assigned in the controller. This applies to the decoder and conventional models. In this article, the following topics are covered:

USA

A new controller installation will begin with at least one or two ATTENTION messages, because the controller has experienced a "power outage" in shipping, and might be discovering new modules. This is normal. Messages on the screen do not interfere with normal irrigation.

When power is first turned on (either with the power switch, or closing one of the slide locks), the Hunter logo screen appears, and the controller begins searching for any irrigation events it may have missed during a power outage.

USA

About this event

Les esperamos en nuestro stand situado en el pabellón 3, calles E/D, núm 13-14

Si desea recibir una invitación para participar en la feria puede solicitarla en la dirección siguiente: http://www.feriazaragoza.es/invitacion_electronica.aspx