Controllers - Programming Multiple Programs Part 4 of 4: Other Modes
Programming a controller is easy. You just need to program the current day and time and you are ready to create a program for your zones or stations. It
Controllers - Programming Multiple Programs Part 3 of 4: Program B
Programming a controller is easy. You just need to program the current day and time and you are ready to create a program for your zones or stations. It
Controllers - Programming Multiple Programs Part 2 of 4: Program A
Programming a controller is easy. You just need to program the current day and time and you are ready to create a program for your zones or stations. It
Controllers - Programming Multiple Programs Part 1 of 4: Introduction, Time/Date
Programming a controller is easy. You just need to program the current day and time and you are ready to create a program for your zones or stations. It
Display Troubleshooting on a Hunter Controller
If your display is blank, unreadable, or if it is showing symbols that do not make any sense, this video will teach you how to troubleshoot the display.
Manual Operation with a Hunter Controller
Hunter controllers allow you to start a station or an entire program manually. To do so, turn the dial to Manual Single Station or Manual All Stations
Hunter X-Core Programming 1 of 2: Overview and Setting Up Program A
In this video Hunter Technical Services gives you a basic overview of an X-Core controller, and walks you through how to set-up program A.
Hunter X-Core Solar Sync Sensor Installation and Setup
Hunter Technical Services shows you how to properly connect and program a Solar Sync sensor to an X-Core controller.
Cleaning a Filter on a Hunter Rotor
The most common reason for a sprinkler to stop rotating is the accumulation of debris in the filter. This video will teach you how to clean the filter
ICR Remote Control - Setting the Address
If you can activate your stations from your controller, but you can't activate them from your remote control, it is possible that your transmitter is
ICR Remote Control - Programming & Operation
This video provides an overview on how to set up and operate your ICR remote control including how to turn on and off stations as well as changing their
SVC Controller - Programming - Part 2 of 2
The SVC is ideal for applications where electrical power is absent using only a 9-volt battery to operate. The SVC does not require running electrical
SVC Controller - Programming - Part 1 of 2
The SVC is ideal for applications where electrical power is absent using only a 9-volt battery to operate. The SVC does not require running electrical
SVC Controller - Reset
If want to clear the memory on your controller and start from fresh, or if your controller is not responding to your commands, this video will show you
Valve Series: Valve Operation
This video will teach you the components and operation of an Hunter irrigation valve. You will learn how to manually open and close your Hunter valve
Installing a Nozzle on a Hunter Rotor
Installing a nozzle on a rotor is relatively easy. The procedure is the same for the PGJ, SRM, PGP-ADJ, PGP Ultra and I-20 rotors. This video will teach
Replacing a Hunter Rotor Riser Seal
One of the most common reasons for a sprinkler to start leaking between the pop-up riser assembly and the body cap while it is in operation is because
Hunter Rotor Right Stop Alignment
With a rotor tool, it's easy to adjust the left stop, but ever wonder how to adjust the right stop after install? Mike from Hunter technical support
Hunter Spray Adjustments and Maintenance
This video explains how to adjust and maintain Hunter sprays on an irrigation system. Mike, a Hunter Technical Support Representative, demonstrates
Hunter Golf TTS Rotors Field Knowledge
This video introduces TTS (Total Top Service) golf rotors. Rich Dunn, Golf Product Manager, details the servicing procedures for the G800 and G900
