Support
X2 Support

X2 - Programmable Sensor Override

The X2 allows the user to program the controller so that the sensor disables watering on only desired stations. For example, patio gardens that have pots under overhangs and roofs may not receive water when it rains and will continue to need to be watered during periods of rain. To program sensor override, follow the steps below.

NOTE: The controller default is for the sensor to disable watering on all zones when rain occurs.

Step 1

From the RUN position, press and hold the minus (-)button down while turning the dial to START TIMES position.

Step 2

Release the minus (-) button. At this point, the display will show the station number, ON, and the  icon, will be flashing.

Rate this Article: 
0

Was this article helpful? | No