X2 - Connecting Hunter Remote

The X2 Controller is compatible with Hunter Remote Controls (not included). The SmartPort® wiring harness (included with all Hunter Remotes) allows for fast and easy use of the Hunter controls. The Hunter remotes make it possible for you to operate the system without having to walk back and forth to the controller.

To install the SmartPort connector

1

Install a ½" female threaded “Tee” in the field wiring conduit approximately 12" below the X2.

2

Route the red, white, and blue wires of the harness through the base of the “Tee” and into the wiring compartment as shown.

3

Screw the SmartPort harness housing into the "Tee" as shown.

4

Attach the red, white, and blue SmartPort wires to the controller terminal as shown

  • Red wire to left side "24VAC" terminal
  • White wire to right side "24VAC" terminal
  • Blue wire to "REM" terminal

Still need help? We're here.

Tell us what you need support with and we'll find the best solution for you.

Contact Support