Mini-Clik -Test Sensor Operation

Share
Topics: 
FAQs, Troubleshooting

Operation Check to Verify Correct Wiring

Turn on one zone of the irrigation system that is visible while you are in reach of the Mini-Clik. Manually depress the spindle at the top of the Mini-Clik until you hear the switch “click” off. The sprinkler zone should stop instantaneously. If it does not, check wiring for correctness. It is not necessary to “wet” test the Mini-Clik, although it will test the operation fine, if desired.

When testing the sensor always use a Manual ALL Stations or Manual Program Start. Under a Manual Single Station start the rain sensor will be ignored and the sensor will not shut down the water.

Once the Manual ALL Stations is initiated, go to the sensor and hold down the Quick Response Spindle button and the water will shut down.


 

 

Resources

Rate this Article: 
Average: 4 (4 votes)

Related Links