Residential Rotors Support

Residential Rotors - SRM Nozzle Installation

If the top of the screw is below the top of the turret, the screw must be turned counter-clockwise until it is flush with the top before removing the nozzle. If the screw is flush with the top of the nozzle turret, the nozzle can be installed by reversing the steps above.
  1. Nozzle ID Tab
  2. Radius Reduction Screw
  3. Adjustment Socket
  4. Pull-up Socket
  5. Plus+ Minus- Arc Adjustment

Step 1

Use hex end of Hunter wrench to pry nozzle identifier tab up from top of sprinkler.


Step 2

While holding identifier tab, push down and forward on nozzle.

Step 3

Pull nozzle straight out.

Rate this Article: 

Was this article helpful? Ja | No