Welcome Page Body

Section Menu
Basic Programming
-
Setting Current Date and Time
Turn the dial to the DATE/TIME position. The current year will be flashing. Use the and buttons to change the year. Push the button to proceed to setting the month.
-
Setting Program Start Times
Turn the dial to the START TIMES position. Press the button to select A, B, C or D. Use the and buttons to change the start time. The start time advances in 15-minute
-
Setting Station Run Times
Turn the dial to the RUN TIMES position. Use the button to select program (A, B, C, or D). Use the and buttons to change the station run time on the display. You may
-
Cycle and Soak
The Cycle and Soak feature allows you to split a station’s run time into more usable, shorter watering durations. This feature is useful when applying water to slopes and tight
-
Total Runtime Calculator
Turn the dial to RUN TIMES. Press to view total time for all stations in program. Press to see total times for other programs.
-
Setting Water Days
Turn the dial to the WATER DAYS position. The display will show the last program selected. (A, B, C, or D). Switch to another program by pressing the button. The pointer
-
Seasonal Adjustment
Seasonal Adjust is used to make global run time changes without re-programming the entire controller. This feature is perfect for making small changes that are necessary as the
-
Set Pump/Master Valve
The Pump/Master Valve start can be set ON or OFF by station, regardless of which program the station is assigned. The default is for all stations to have the Pump/Master Valve
-
Solar Sync
Sets up and adjusts optional Hunter Solar Sync sensor. Turn the dial to the SOLAR SYNC position Press or to select Region , 1-4 (see Solar Sync support). Press
Manual Operation
-
Manual Station
Turn dial to MANUAL position. Press to select station. Use or to set manual run time. Turn dial to RUN position to begin immediately. NOTE: The Manual
-
Manual Program
With the dial in the Run position, press and hold the ► button for two seconds and release. This manual one touch start option automatically defaults to program A. You
Troubleshooting
-
Test Stations
Runs all stations for a test run time. Press and hold for 3 seconds. Station 1 appears. Press or to enter run time. Wait 2 seconds, each station will run for test
-
Quick Check
Checks all stations for wiring short circuits, commonly caused by faulty solenoids or when a bare common wire touches a bare station control wire. Press , , , at the
-
Reset
Open inner door (control panel). Press RESET button on back of door. Controller restarts. Controller Total Reset (Erase All) Open inner door (control panel)
-
Troubleshooting Guide
Display Possible Cause Solutions DISPLAY SHOWS "ERR" WITH NUMBER Short in field wiring, or bad
-
Hidden and Advanced Features
Feature Where Found Description PROGRAMMABLE SENSOR OVERRIDE Hold and turn to START TIMES