Support
Valves

Valves - Cleaning Debris from an Irrigation Valve

SRV, PGV, 1" PGV, PGV-ASV, ICV

One of your irrigation zones may continue to run or might be stuck on even with your controller unplugged. The valve running without a signal from the controller is an indication that there is debris inside the valve. Here are some tips for valve repair.

  • Często zadawane pytania, Film

Customer Type:

Cleaning Parts and Body
  1. Turn the controller to " System Off" so it does not try to cycle a program.
  2. Shut off the main water supply. Opening a valve under pressure is dangerous and you could be injured.
  3. Unscrew the solenoid (cylinder with two wires) and make sure the plunger is clean and moves freely. You can test the solenoid by running that station manually from the controller and see if the plunger retracts when energized.
  4. Unscrew the bonnet screws or jar top depending on your valve model. Be careful when you pull the bonnet away from the body as to not lose the diaphragm or spring.
  5. The diaphragm may be sitting in the body or captured in the bonnet. Remove the diaphragm and spring. Make note of the orientation of the diaphragm so you can put it back together the same way it came out.
  6. Examine the diaphragm and spring. The diaphragm should be clean and free of wrinkles, tears, or perforations. The seal should be clean and free of nicks, dents or abrasions. Wash the diaphragm with clean fresh water to remove any debris that may have been deposited there.
  7. The diaphragm spring should be intact and bounce back when compressed.
  8. Examine the valve body and remove any debris, pebbles, or dirty water.
  9. The seal seat should be clean and free of nicks, grooves, or abrasions.
Cleaning Ports
  1. Examine the porting in both the valve body and the bonnet. All ports should be clear and pass water freely. A small piece of flexible wire can be passed through the ports to remove blockage.
  2. Reassemble the valve in the reverse order of how it was taken apart. The diaphragm should sit with the lip in the matching groove on both the body and the bonnet. The screws or jar top should be hand tightened. Over tightening can damage the valve.

Cleaning debris from an irrigation Valve

If you are still experiencing problems with your valve, you may need to contact a local professional by clicking on the following link.

Replacement parts (see Resource below) can be purchased through authorized Hunter distributor, click on the Get Hunter link at the top of this page to find distributor locations near you.

Resources

USA
Hunter Replacement Parts Price List
Rate this Article: 
3.2

Was this article helpful? Tak | No

S U P P O R T
M E N U