Hunter Technical Support Document

Share

Node - Setting Watering Days

Tabs

Read Article
Installation Procedures
Setting Watering Days
  1. Press the button until the icon is displayed.
  2. The program letter (A, B, or C) will be displayed.
  3. Arrows point at the specific days of the week in which watering will occur. Press the plus (+) or minus (-) buttons to scroll though the days.
  4. Press the plus (+) button to activate that day for the program displayed, or the minus (-) button to cancel watering for that day. The arrow will show on the watering days for the active program.
  5. Press the PRG button to set days to water for a different program, if desired.
  6. Press the button to proceed to the next programming function or allow controller to return to idle mode.
Selecting Odd/Even Days to Water

This feature uses numbered days of the month for watering instead of specific days of the week.

  1. Press the button until the icon is displayed.
  2. Press the right arrow button until the cursor is above either ODD or EVEN on the display.
  3. Press the plus button to select, or the minus button to cancel either ODD or EVEN days to water.
  4. Once ODD or EVEN mode is activated it will be the only cursor shown on the display.

 

Selecting Interval Days to Water
  1. Press the button until the icon is displayed.
  2. Press the right arrow button until the cursor is above INT on the display.
  3. Press the plus button and a 1 will be flashing indicating the number of days between watering.
  4. Press the plus or minus button to select the number of days between watering days (1 to 31).
Rate this Article: 
No votes yet