Hunter Technical Support Document

Share

Soil-Clik - Using with Solar-Sync

Tabs

Read Article

When paired together, the Hunter Solar Sync and Soil-Clik make the ultimate smart irrigation solution for your sprinkler system.  Solar Sync adjusts run times for weather conditions, and provides rain and freeze shutdown. Soil-Clik prevents unnecessary watering when soil is still wet.

X-Core, Pro-C, PCC

1. Connect Solar Sync to controller sensor terminal, as usual. If the Pro-C does not have the Solar Sync Settings on the dial, connect Solar Sync using the Solar Sync Module.

2. Connect Soil-Clik as shown in “Common Interrupt”. Do not connect to SEN terminals if Solar-Sync is present.

I-Core (version 3.0 and later)

1. Connect Solar Sync to S1. If the I-Core does not have the Solar Sync Settings on the dial, connect Solar Sync using the Solar Sync Module.

2. Connect Soil-Clik white wires to S2 (or S3 in larger capacity versions).

3. With the dial at Set Sensor Operation, assign Solar Sync (S1) by program, and Soil-Clik (S2) by station.

ACC (version 5.0 and later)

1. Connect Solar Sync to ET terminals.

2. Connect Soil-Clik to S1, S2, S3, or S4.

3. With the dial at Set Sensor Operation, assign Solar Sync and Soil-Clik by program. The Solar Sync will be assigned to 2 sensors (one for Rain, one for Freeze)

 

Installation Procedures
Rate this Article: 
No votes yet