|Hold – and turn to Start Times
|Sets individual stations to ignore sensor shutdowns. Select stations with ◄ or ►, then use
+/– to change to Off to ignore the sensor.
|Cycle and Soak
|Hold + and turn to Run Times; enter
Cycle and press PRG to set Soak
|Sets max time a station can run at once and minimum time it must wait before another
cycle. Divides run time into segments to prevent runoff.
|Hold – and turn to Run Times
|Inserts a delay (seconds or minutes) between stations in a run time for slow valves or
|Hold – and turn to Water Days
|Use +/– to change from 4 to 1 to hide extra programs. 1 will show only Program A, start
time 1. 4 will show all programs (A, B, C) and 4 start times per program.
|Solar Sync Delay
|Hold + and turn to Solar Sync
|Sets number of days before the Solar Sync Sensor begins adjusting run times. Allows
landscape establishment for a set period of days before the sensor begins adjusting
|Hold + and turn to Off
|Set number of days for watering to remain off after sensor has been activated and
|Total Run Time
|Turn to Run Times; press ◄ when station
1 is shown and PRG to select other
|Calculates and displays the total of all run times in a program start time.
|Hold PRG 3 seconds
|Runs all stations in the controller for the time entered for test or diagnostic purposes.
|Hold + and PRG to Save
Hold – and PRG to Restore
|Saves all program information to restore at a later time.
|Press PRG and Reset button
|Erases all watering information.
|+, –, ◄, ► together, then +
|Checks all stations for wiring problems.
|Hold ►, PRG to select
|Runs all stations in selected program; use ► to advance to next station.
|Hold + and turn to Start Times
|Optional Seconds Mode allows for seconds of Run Time resolution, up to 5 minutes.
Press + and - buttons to toggle between Seconds and Minutes Modes.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.