Support
Soil-Clik Support

Soil-Clik - Connecting to Pro-C

Soil-Clik™

Soil-Clik: Wiring Specific Controllers

Series
2 of 3

Soil-Clik Installation & Programing

PrevNext
1Soil-Clik: Installation and Setup
▸Soil-Clik: Wiring Specific Controllers
3Soil-Clik: Connecting a Soil-Clik and a Solar Sync
Back
Search all videos
More Hunter Videos ▼
Right-click on the video format below and select Save As...MOV | WMVDownload

Category:

  • Field Knowledge

Product Lines:

  • Controllers, Sensors
Products: 
Soil-Clik™, Pro-C®, X-Core®, I-Core®, ACC

Length:

  • Quick Tip
Published: 
May 12, 2014

Learn to wire your Soil-Clik moisture sensor with Hunter's Pro-C, X-Core, I-Core, and ACC irrigation controllers. Soil-Clik can also be installed on non-Hunter controllers by interrupting the common wire to interrupt the valves when the soil is wet.

  1. Yellow power wires to Pro-C AC1 and AC2.
  2. White wires to Sensor or common interrupt. Remove jumper plate from Sensor Terminals.
  3. Gray wires to PROB.

Connecting the Module to Hunter Pro-C

  • Installation Procedures
Rate this Article: 
0

Was this article helpful? Yes | No

S U P P O R T
M E N U