Support
Commercial Rotors

Installing the I-40 Turf Cup Kit

Step 1

Access the top cover screws by prying out the little covers one at a time. 

Step 2

Remove plastic screw covers.

Step 3

After the screws are exposed, you can use a common Phillips head screwdriver to remove them.

Step 4

Remove both screws.

Step 5

Once the screws are removed, you can now take off the stock body cap.

Step 6

If done properly, the riser seal and riser seat should still be in place.

Step 7

You can now push on the turf cup body cap, while it's compressed tighten the screws.

Step 8

Hold cap while tightening screws.

Step 9

Tighten both screws.

Resources

Rate this Article: 
4.5

Was this article helpful? نعم | No