Support
X-Core Support

X-Core - Connecting a Hunter Remote

Step 1

Install a ½" female threaded “Tee” in the field wiring conduit approximately 12" below the X-Core.

Step 2

Feed the red, white, and blue wires of the harness through the base of the “Tee” and into the wiring compartment as shown.

Step 3

Screw the SmartPort harness housing into the "Tee" as shown.

Step 4

Attach the red, white, and blue SmartPort wires to the controller terminal as shown

  • Red wire to left side "24VAC" terminal
  • White wire to right side "24VAC" terminal
  • Blue wire to "REM" terminal
Rate this Article: 
0

Was this article helpful? Yes | No