Support
X-Core Support

X-Core - Connecting a Pump Start Relay

X-Core™
  • Installation Procedures

Step 1

Route a pair of wires from the pump relay into the controller.

Step 2

Connect a common wire to the C (Common) terminal inside the controller and connect the remaining wire from the pump start relay to the P (Pump) terminal.

Relay holding current draw must not exceed 0.3 A. Do not connect the controller directly to the pump or damage to the controller will result.

  1. 15 ft. Minimum
  2. PSR Series Pump Start Relay
  3. To Pump

Rate this Article: 
0

Was this article helpful? Yes | No

S U P P O R T
M E N U