X-Core Support

X-Core - Programmable Sensor Override

Step 1

Turn the dial to the RUN position.

Step 2

Press and hold the minus (-) button down while turning the dial to START TIMES position.

Step 3

Release the minus (-) button. At this point, the display will show the station number, ON, and the icon, will be flashing.

Step 4

Press the plus (+) or minus (-) button to enable or disable the sensor for the station shown. ON = Sensor enabled (will suspend irrigation). OFF = Sensor disabled (will allow watering).


Step 5

Use the left arrow (<) or right arrow (>) buttons to scroll to the next station that you would like to program the sensor override. Turn the dail to Run after programming sensor override.

Rate this Article: 

Was this article helpful? Yes | No