Support
EZDS Support

EZDS - Installing the EZ-DM

Tabs

Read Article

If the whole system will be two-wire, install the EZ-DM module in the first slot in the controller. Press the Reset button on the back of the controller face panel for the new module to be recognized.

Step 1

  • Open blue lock lever.
  • Insert module tabs into end of slot, and tip into place.

Step 2

Close locking lever

Step 3

Press controller Reset button. Controller will then recognize the new module, and the controller size will change to 54 stations.

Rate this Article: 

Was this article helpful? Yes | No