Support
EZDS Support

EZDS - Operation

Tabs

Read Article

EZ Decoders do not require special operating procedures, and the programmed decoders will operate exactly like conventionally-wired stations. When a decoder station begins to operate, the EZ-DM light will blink rapidly while first communicating, then blink at approximately one-second intervals during the station run time. When the EZ-1 decoder is actively running, the decoder LED will also blink at approximately one-second intervals. If the decoder light does not blink when the controller display indicates the station is running, the decoder may be either disconnected or damaged.

NOTE: The Hunter ICC2 QuickCheck™ feature cannot work with EZ Decoders! The function will still work with any conventional stations in a hybrid system, but is not intended for use with EZ Decoders.

Rate this Article: 

Was this article helpful? Yes | No