Hunter MP Rotators fit on a traditional pop-up or fixed spray body. The most common bodies are the female threaded version. MP Rotators are also available in a male thread version if needed. MP Rotators make a great replacement for spray nozzles, adding the benefit of being a much more efficient nozzle with low precipitation and matched uniformity.
When replacing spray nozzles with MP Rotator you will need to at least double your run time, which will still save you about 30% more water than spray nozzles.
- Pull up the body riser and hold in raised position. Remove the current spray nozzle by holding the body and unscrewing counter clockwise.
- Note: Be sure to also remove the nozzle screen, as most are not attached to the spray nozzle.
- To Install MP Rotator, screw on the MP Rotator by turning clockwise till the hand is tight. Install the MP Rotator with the Left Edge Indicator pointing to the left side of the desired watering pattern.
- Note: After replacing the nozzle, ensure no debris gets in the body. If debris enters the body, flush the line without the nozzle attached.
Hunter MP rotators should be designed with head to head spacing for optimal performance.
Warning: If your nozzles are not covering the desired distance, you may need to move up to a longer arc nozzle.
Warning: Do not mix Spray Nozzles with MP Rotators in the same zone. MP Rotators have a much lower water application rate and should run longer. If a spray is in the same zone, it will severely overwater in that location.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.