Welcome Page Body
Welcome to the ICD-HP handheld decoder programmer support section. The ICD-HP works with the Dual, ACC-99D and Pilot decoder system. In this section you will find information on setting up and using ICD-HP with decoders.
Section Menu
ICD-HP Components
-
ICD-HP Components
ICD-HP Programmer Programming Cup Programming Cable 6' (2 m) with connectors Red and Blue 6' (2 m) leads USB A to mini-A 3' (1 m) cable 4 x AA batteries Carrying
Firmware Update
Installation
-
Installing The Batteries
The ICD-HP programmer operates with 4 x AA batteries. The batteries supplied are not rechargeable!
-
Connecting to a Decoder
The ICD-HP programmer works with Hunter ICD and later decoders. The ICD-HP programming cup communicates with decoders through wireless induction. The bottom end of the decoder
Operations
-
Main Menu and Navigation
Turn the programmer on with the power button. The logo will appear and change to the Main Menu in a few seconds.
-
ICD-HP Setup
LCD Settings Adjust screen appearance with Contrast, Backlight, and Backlight Timeout controls. Use the arrow buttons to move to the item you wish to change, and press the + or
-
Diagnostics
The Diagnostics menu allows operation and test of decoder functions, along with some sensor and controller test functions. From the Main Menu, move the pointer to Diagnostics and
Troubleshooting
-
Troubleshooting
Choose from the topics listed below: Comm Unsuccessful Stations will not turn on The decoder will not respond after a firmware update Poor battery life Dual/Pilot