Installing the Remote On-Off-Auto Selector Switch and Solenoid Assembly

The on-off-auto selector switch allows the user to control the kit to automatically actuate from an irrigation controller or manually from the switch. To install the switch, make sure it’s positioned directly below an access port in the vault’s cover set.

  1. Drill two pilot holes with a 5/ 16" masonry drill bit in the sidewall of the vault. The pilot holes should be 1" (25 mm) apart.
  2. Mount the switch with the supplied hardware and bolts.
  3. Lastly, connect the solenoid using the recommended 3M DBRY high-quality wire connectors.

 

Still need help? We're here.

Tell us what you need support with and we'll find the best solution for you.

Contact Support