From Main Menu, dial to the Programs menu and select. This is where basic automatic irrigation is set up. A basic program requires Start Times, Run Times, and Water Days to operate automatically. There are 32 possible automatic irrigation programs, each with up to 10 Start Times. Verify that you have the correct program number, or select and enter the program you want.
A name can be entered here to label the program. This is optional.
Auto: Must be set to Auto to run automatically. Enter the time for the program to start. Each program may have up to 10 start times.
Start to End: Allows you to run the program automatically from a selectable start time to a selectable end time. The number of cycles will appear to the right next to Estimated Cycles.
Manual Only: Does not water automatically, but stores station run times for manual irrigation only. These programs do not have day schedules or start times. They may be changed to Auto mode at any time, if automatic operation is desired.
Stack means the program must run by itself. Overlap means it is allowed to run at the same time as other programs. If a program is stacked, its actual start time may change, if other programs overlap it in time.
ACC2 has no artificial programming limits preventing overlapping programs and stations. The controller senses how much electrical current is being drawn, and will suspend stations automatically if the combined current threatens the transformer.
It is also possible to set controller and station limits (Stations, Station Limits) to control how many outputs may operate at once.
A conventionally wired ACC2 may run as many as 14 Hunter solenoids (including any P/MV outputs) simultaneously before suspending additional stations. Environmental factors or higher-draw solenoids may cause the overcurrent protection to activate at lower station counts.
It is possible to view the current draw of each station in the Diagnostics menu.