Support
ACC2 Support

ACC2 - Manual Starts and Test

From the Home screen, the MANUAL soft key allows you to start stations/blocks, programs, and run a test program. A Manual Station or Program Start will pause any automatic watering until the Manual Program has been completed.

Manual Station

Manual Program

Test Program

Manual Stations

Select one or more stations to run manually with any amount of run time.

  1. Select the right soft key MANUAL.
  2. Select the right soft key MANUAL STATIONS.
  3. The default RUN TYPE is sequentially (one after another).  Check the Simultaneous box to have the selected stations run simultaneously.
  4. Using the scroll wheel, select an EVENT. An event can be a single station or a block (group of stations).
  5. Using the scroll wheel, select a STATION NUMBER.
  6. Using the scroll wheel, select a RUN TIME.
  7. Select soft key START.
  8. Select soft key STOP to stop the operation.

Manual Program

Select a single PROGRAM to run manually that has preprogrammed information in the controller.

  1. Select the right soft key MANUAL.
  2. Select the right soft key MANUAL PROGRAM.
  3. Using the scroll wheel, select a PROGRAM NUMBER.
  4. Select soft key START.
  5. Select soft key STOP to stop the operation.

Test Program

The TEST PROGRAM will run all stations in the controller for the run time entered on the screen.

  1. Select the right soft key MANUAL.
  2. Select the right soft key TEST PROGRAM.
  3. Using the scroll wheel, select a RUN TIME.
  4. Using the scroll wheel, select a STATION number to start on. It is also possible to specify a station number, and run all remaining stations from that number to the highest numbered station.
  5. Select soft key START.
  6. Select soft key STOP to stop the operation.

Rate this Article: 
0

Was this article helpful? Yes | No

S U P P O R T
M E N U