NOTE: Complete this section only if you have a pump start relay installed. A pump start relay is a device that uses a signal from the controller to actuate a separate electrical circuit to energize a pump to provide water to your system.
The controller should be mounted at least a 15 ft (4.5 m) away from both the pump start relay and pump to minimize any potential electrical interference.
Route a pair of wires from the pump relay into the controller.
Connect a common wire to the C (Common) terminal inside the controller and connect the remaining wire from the pump start relay to the P (Pump) terminal.
Relay holding current draw must not exceed 0.3 A. Do not connect the controller directly to the pump or damage to the controller will result.
- 15 ft. Minimum
- PSR Series Pump Start Relay
- To Pump
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.