Support
Pro-C Support

Pro-C - Manually Run a Single Station

Pro-C®

Manual Operation with a Hunter Controller

Back
Search all videos
More Hunter Videos ▼
Right-click on the video format below and select Save As...MOV | WMVDownload

Category:

  • Field Knowledge

Product Lines:

  • Controllers
Products: 
X-Core®, XC Hybrid, Pro-C®

Length:

  • Quick Tip
Published: 
June 16, 2010

Hunter controllers allow you to start a station or an entire program manually. To do so, turn the dial to Manual Single Station or Manual All Stations, verify that the stations that you want to activate have run time, and turn the dial back to the Run position. When the station or stations finish watering the controller will go back to normal automatic operation.

  • Installation Details
System Off

Valves currently watering will be shut off after the dial is turned to the SYSTEM OFF position for two seconds. All active programs are discontinued and watering is stopped. To return controller to normal automatic operation, simply return dial to the RUN position.

Manually Run a Single Station
  1. Turn the dial to the MANUAL position.
  2. Station run time will flash in the display. Use the  button to move to the desired station. You may then use the   and   buttons to select the amount of time for a station to water.
  3. Turn the dial to the RUN position to run the station (only the designated station will water, then controller will return to automatic mode with no change in the previously set program). When the station is running you will see a flashing on the display.

 

NOTE:
The Manual single station function ignores any attached sensor and will allow watering to occur. Do not use Manual single station to test rain sensor. Use the One Touch Manual Start to test Rain Sensor operation.

 

Rate this Article: 
0

Was this article helpful? Yes | No

Support Menu

S U P P O R T
M E N U