Solar Sync - Connecting to the ICC2

The ICC2 controller is programmed with Solar Sync technology and, therefore, does not require the use of the Solar Sync module.

The Solar Sync Sensor (SOLARSYNCSEN or WSSSEN) is wired directly to the “SEN” terminals on the ICC2 controller.

Wired Solar Sync Sensor Installation

Connect the Green and Black wire from the Solar Sync Sensor directly to the “SEN” terminals on the ICC2 controller as shown on image to the right. It does not matter which wire connects to which terminal. Turn the dial to the “Solar Sync” position. The display will initially show dashed lines and then will show the default Region setting (3) on the left and the default Water Adjustment setting (5) on the right.

Adjust the Region by using the up or down arrows. Press the right arrow once, the Water Adjustment will be flashing. Adjust the Water Adjustment by using the up or down arrows.

 

Wireless Solar Sync Sensor Installation

Connect the Green and Black wire from the Wireless Solar Sync Receiver directly to the “SEN” terminals on the ICC2 controller as shown on image to the right. It does not matter which wire connects to which terminal. Turn the dial to the “Solar Sync” position. The display will initially show dashed lines and then will show the default Region setting (3) on the left and the default Water Adjustment setting (5) on the right.

Adjust the Region by using the up or down arrows. Press the right arrow once, the Water Adjustment will be flashing. Adjust the Water Adjustment by using the up or down arrows.

 

 

Still need help? We're here.

Tell us what you need support with and we'll find the best solution for you.

Contact Support