Support
NODE Support

Node - Connecting A Weather Sensor

NODE

A Hunter Mini-Clik® or Rain-Clik® rain sensor can be connected to the NODE. The purpose of this sensor is to stop watering when weather conditions dictate.

NOTE:
When the Rain Sensor is interrupting the watering, the display will show the System Off icon, “OFF” and on the display.

Wireless Rain Sensors are not compatible with the NODE.

  • Installation Procedures
  1. Cut the yellow wire loop attached to the NODE at approximately the middle of the loop.
  2. Remove approximately 1⁄2" (13 mm) of insulation from each wire. Attach one yellow wire to each of the wires of the weather sensor. You can mount the rain sensor up to 100 ft (30 m) from the NODE controller (18AWG/1.0 mm minimum wire size).
  3. Secure wire connections with waterproof connectors.
Rate this Article: 
0

Was this article helpful? Yes | No

S U P P O R T
M E N U