Support
NODE Support

Node - Setting the Run Times

Setting Station Run Times

The Station Run Times mode allows you to enter a length of run time for each station assigned to a particular program ( A, B, or C). Each station that has a run time associated with a program will be activated and operate one after another sequentially with each start time for that program.

  1. Press the button until the icon is displayed.
  2. The run time will be displayed flashing. Also shown is the program letter (A, B, or C) and the active station # on the lower left side of the display. Press the plus or minus button to change the station run time from 1 minute to 6 hours.
  3. Press the right right arrow button to advance to the next station.
  4. Press the PRG button to add a run time to another program.
  5. Press the button to proceed to the next programming function or allow controller to return to idle mode.

NOTE: After programming the run time for the last station press the right arrow (>) button to display the total run time for the program.

Rate this Article: 
0

Was this article helpful? Tak | No