Metal controllers will include a hole plug assembly in a pre-drilled factory hole on top of the controller. Remove the nut on the inside of the controller to remove the plug. Route the cable through the pre-drilled hole and the antenna nut. Then tighten the nut on the antenna securely. Apply RTV sealant around the hole, filling the gap between the enclosure hole and the mounting threads. Route the antenna cable through the track on the back of the door frame to the module in the facepack. Leave just enough slack to allow the door to open and close without pinching the cable. Connect the cable to the module and tighten by hand.
The antenna must be installed outside the controller enclosure on a metal bracket. Do not drill the enclosure directly. These installations require a Hunter wall bracket (P/N - WALLANTBRKT) to complete the installation. The antenna includes approximately 9' (2.8 m) of cable.
Plastic pedestal mounting requires a lid adapter (P/N -PEDLIDANTBRKT).